There are some scenarios where we want to assign multiple IPs from different VLAN on the same Ethernet card (nic) on Linux servers (CentOS / RHEL).This can be done by enabling VLAN tagged interface. But for this to happen first we must make sure multiple VLANs are attached to port on switch or in other words we can say we should configure trunk port by adding multiple VLANs on switch.
The first Ethernet interface is usually identified as eth0. To configure a DNS server, add the dns-nameservers IP_ADDRESS line under the eth0 configuration: The line dns-nameservers 8.8.8.8 sets up a DNS server with the IP address of 8.8.8.8 as our DNS server (it is a public DNS server from Google). How to set up an usb/ethernet interface in Linux? I have an usb to ethernet adapter connected to my linux system. I edited the connection information, and gave manual ip 192.168.1.21 in the connections menu available at the top right. In the above command lines we can see the available connection information on my system. How to configure network in Red Hat Linux - GoLinuxHub
25.5. Configuring a Fibre Channel over Ethernet Interface
01:00.0 Ethernet controller: Broadcom Corporation NetXtreme BCM5764M Gigabit Ethernet PCIe (rev 10) 37:09.0 Ethernet controller: Broadcom Corporation NetXtreme BCM5782 Gigabit Ethernet (rev 03) Linux configuration for a new card: HowTo: Change Speed and Duplex of Ethernet card in Linux HowTo: Change Speed and Duplex of Ethernet card in Linux. Posted on Tuesday December 27th, 2016 Friday February 24th, 2017 by admin. To change Speed and Duplex of an ethernet card, we can use ethtool – a Linux utility for Displaying or Changing ethernet card settings. 1. Install ethtool. How to configure a static IP address on CentOS 7 / RHEL 7
How To Configure Static And Dynamic IP Address In Arch Linux
On modern Linux including CentOS 7, network interfaces have names such as ens33. If your network interface name starts with en, then it’s an Ethernet cable directly plugged in. If your network interface name starts with wl, then it’s a WiFi interface. Note that the FQDN of the host can be supplied by a DNS resolver, by settings in /etc/sysconfig/network, or by the /etc/hosts file. The default setting of hosts: files dns in /etc/nsswitch.conf causes the configuration files to be checked before a resolver. HowTo: Change Speed and Duplex of Ethernet card in Linux Posted on Tuesday December 27th, 2016 Friday February 24th, 2017 by admin To change Speed and Duplex of an ethernet card, we can use ethtool – a Linux utility for Displaying or Changing ethernet card settings.